Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hi
I need to 3 phase ac supply voltage by using voltage divider circuit. voltage divider output is given to microcontroller adc pin. Any one update voltage divider circuit for rectify this mistake.
either you connect your signal GND to one of the phases and measure the other two phases referenced to it,
or you use three voltage divider (2 x two resistors) and refer all three to your signal gnd.
With no other currents (isolation or capacitive coupling) you can measure all the phases independently.
In reality you will have to do some maths to get the correct voltages.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.