Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

2xThru de-embedding 1-port device

Status
Not open for further replies.

Tybi

Newbie level 5
Joined
Sep 1, 2021
Messages
8
Helped
0
Reputation
0
Reaction score
0
Trophy points
1
Activity points
58
Hello,
is it possible to de-embed a one port device with a 2xThru de-embedding structure? The 2xThru de-embedding structure is twice the test fixture. To de-embed the 1-port DUT I only need one half of it. I know that the de-embedding algorithm splits the 2xThru in two halfs, but I'm not shure if transmission in the DUT is required for de-embedding.
Thanks!
 

I need to characterize a match calibration standard on a pcb.
 

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top