Hi there,
I'm working on a project and i want to use 628's internal clock.I'm programming on ccs c++ compiler.So how will i modify my code and how will i modify my circuit?(Esp. osc. section) By the way is it safe like xtall?
Can you explain everything deeply please?
I am using few hundreds of PIC16F628 with INTRC (4 MHz) now on -25 C without any problem. Also they worked on +80 C (on tests). Frequency stability is good enough, as in specification. I had some problems with WDT timers - they have big frequency difference.
Thank you very much.It will be helpful for me.I have a device so how will i modify the oscillator section of my device? Just cancel xtall and its 2 capacitors?Will i connect someting? Can anyone send me a design (jpg,bmp) that uses internal clock?
Analyzer
It's simple. You have config bits for define which oscillator is used (RC, Xtal, internal RC etc.). So, you when you use internal clk two pins where you connect xtal and capacitors to gnd can be port pins or internal clk out so you can sinhronize some other hardware to clk of your controller.
Those config bits I set in software for programming pic (I use picprog).