Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

12V DC to AC converter circuit ??

Status
Not open for further replies.

mmohsen

Advanced Member level 4
Joined
May 19, 2005
Messages
100
Helped
7
Reputation
14
Reaction score
2
Trophy points
1,298
Activity points
2,425
dc to ac circuit

Dear All

Can anybody help me to find an Ac-to-DC converter circuit works on 12V to drive an AC-motor? (i need a reliable one)

Best Regards
 

dc to ac converter circuit

I also have some circuits which I made. Tell me your power requirement.
 

dctoac convertor cir cuit for

hi. i also have some circuit (sch and pcb) for switch mode dc/ac converter. 100w to 1500w. how much power your ac motor.

Added after 6 minutes:

hi . here 100w switch mode 12VDC to 220V AC converter.
 

dc to ac converter circuits

Just a word of caution. Make sure that whatever circuit you end up using is capable of powering an inductive load. Many of the DC-AC converters have a square wave output and that will certainly not make your AC motor very happy.

Mike
 

500w low cost 12v to 220v inverter circuit

sorry i forget about the output wave. its output waves is modified sin. its like ladder (up and down).
 

dc to ac 12v

hi.
here is 1500W Inverter Full Schematics And Pcb
 

500w 12vdc to ac 220v converter

cae20452 said:
hi.
here is 1500W Inverter Full Schematics And Pcb

ttp://
the link is not work
could u upload the circuit here??
have a nice day :)
salam
Ahmed
www.i-g.org
 

circuit convert 12v dc to 220v ac

sory about the link problem.
here is 12V to 220V 1500W switch mode inverter .


now its ok.

have a nice day...
 

12 vdc converter 220 ac 500w

Hi cae20452;
I think this is a good design, i have a question:
in your circuit diagram you use push pull configuration for first stage.
could you please tell me, how you avoid or prevent from transformer saturation in first stage?

Regards,
Davood.
 

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top