buenos
Advanced Member level 3
- Joined
- Oct 24, 2005
- Messages
- 960
- Helped
- 40
- Reputation
- 82
- Reaction score
- 24
- Trophy points
- 1,298
- Location
- Florida, USA
- Activity points
- 9,116
hi.
if i want to route differential pairs with altium, it stucks too often.
For example it routes 1cm, then it stucks, and doesnt want to continue. even if the length matching is loose.
Sometimes i want to route 3mm but it tries to route 1cm and because there is a component 7mm away, it stucks, and doesnt route the 3mm.
Some cases if i try to route on the top layer, and there is a component on the bottom layer in the way, it stucks. It seems like if it thinks that the component is on the top layer.
So i have to route with normal routing. Or route a little piece, select the traces, then move the end of the traces to the right way. then the clearance will be the specified value.
if i want to route differential pairs with altium, it stucks too often.
For example it routes 1cm, then it stucks, and doesnt want to continue. even if the length matching is loose.
Sometimes i want to route 3mm but it tries to route 1cm and because there is a component 7mm away, it stucks, and doesnt route the 3mm.
Some cases if i try to route on the top layer, and there is a component on the bottom layer in the way, it stucks. It seems like if it thinks that the component is on the top layer.
So i have to route with normal routing. Or route a little piece, select the traces, then move the end of the traces to the right way. then the clearance will be the specified value.