Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

MPLAB baudrate 9600 support.

Status
Not open for further replies.
M

MathGeek

Member level 3
Joined
Aug 16, 2005
Messages
67
Helped
1
Reputation
2
Reaction score
1
Trophy points
1,288
Activity points
1,806
I use MPLAB 7.5 and and old ICD2.

My ICD2 gets buggy at baudrate higher than 9600, but MPLAB 7.5 does not give me an option of choosing 9600 (older version that I used had this option.)


Does anyone know how to get around this problem?

It may be complicated since I use USB-to-Serial converter.

Thanks.
 

I was never able to run ICD2 on the serial channel reliable. I think it's MPLAB problem - I posted this problem on Microchip forum long time ago and they told me - just go to USB and forget about serial on ICD2.
 

Thanks for your reply.

So my programmer worked very reliably on 9600 on older MPLAB. On 19200, sometimes it works sometimes it does not work.

The good news is that it works flawlessly at the moment. I dont' know if this is a permanent cure (let's hope it is!), but maybe the board had to be "burnt in" for higher baudrate.


my 2cents.
 

stopped working.

man, this is sad.
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top