Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Looking for tutorials for Smith Chart

Status
Not open for further replies.
S

ssword

Newbie level 1
Joined
Sep 26, 2006
Messages
1
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Activity points
1,289
Does anyone have a good tutorial on the Smith Chart? I am faced with some impedence matching problems, and need some resources to fully understand this tool.

Also, any ideas on any good and modern Smith Chart software would also be greatly appreciated.

Thanks!
 

Smith Chart

Pozar's "microwave engineering" maybe helpful
 

Smith Chart

there are many tutorial
http://www.circuitsage.com/matching.html
http://www.rfcafe.com/

and many tolls on these site

**broken link removed**

Dr. Fritz Dellsperger
Berne Institute of Technology / Switzerland
Smith 2.00 - advanced Smith Chart software

this is Best toll !!

Added after 4 seconds:

there are many tutorial
http://www.circuitsage.com/matching.html
http://www.rfcafe.com/

and many tolls on these site

**broken link removed**

Dr. Fritz Dellsperger
Berne Institute of Technology / Switzerland
Smith 2.00 - advanced Smith Chart software

this is Best toll !!
 

    S

    ssword

    Points: 2
    Helpful Answer Positive Rating
Re: Smith Chart

The Yin-yang of Matching-Part1, part2 -Practical matching techniques

in High frequency Electronics magazine March 2006,April 2006.

Added after 3 hours 14 minutes:

Refer A Practical Introduction to impedance matching
written by Robert L. Thomas

here iam attaching the yin yang of matching part2-practical matching techniques
 

Attachments

  • hfe0406_rhea-part2_5746.pdf
    345.7 KB · Views: 110

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top