Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

matrix board layouting software??

Status
Not open for further replies.
B

buts101

Full Member level 3
Joined
Apr 29, 2005
Messages
168
Helped
3
Reputation
6
Reaction score
2
Trophy points
1,298
Activity points
2,867
hello guys,,

you know, those matrix board ( the board which has holes along row and column...column run from "A B ..." and row run to "1 2 ...".

I need to solder number of device in it..but due to large no connecting wire i require to connect...it may look lay the cobweb...i like to may good.

so, i need the software which give me circuit layout for that matrix board?

looking to hear from u

thank you
 

you can use any PCB Layout tools, if your component count is small, you may use that in demo modes itself.

Few PCB Layout tools are PADS, PROTEL, PCAD, ORCAD.
Hope,I addressed your problem correctly.
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top