Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

split nets in Orcad Layout

Status
Not open for further replies.
B

Beffo

Junior Member level 2
Joined
Feb 21, 2006
Messages
22
Helped
1
Reputation
2
Reaction score
1
Trophy points
1,283
Activity points
1,493
I want to split a net in two in Orcad Layout.... How to do?


The reason is: There is a MOSFET Bridge with high currents. There shall also be sensing components connected to the bridge.

My problem is that the small signal sensing components also gets routed with "fat" connections. So I want the components to belong to different NETS...
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top