Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Need Help in using Atmel's MIxer IC U2795B

Status
Not open for further replies.
M

Muhammad Furqan

Newbie level 6
Joined
Feb 14, 2005
Messages
14
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Activity points
1,414
i am designing Mixer using Atmel's U2795B with LO at 2.25GHz and RF at 300MHz.
IC is showing very low resistence (80 Ohm) between supply and return path (ground) and because of this a very large current starts flowing exceeding the maximum current rating of IC.
if any one has used this IC reply me.
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top