Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

time delay with op-amp

Status
Not open for further replies.
satya_vijayawada

satya_vijayawada

Full Member level 2
Joined
Aug 17, 2005
Messages
121
Helped
22
Reputation
44
Reaction score
11
Trophy points
1,298
Activity points
1,948
opamp delay

Hi
I want a op- amp(LM324) based one second time delay startup circuit

with regards
satya
 

delay opamp startup

Use 1/4 of 324 in "comparator" configuration - see picture below ..
Time dalay of a RC circuit can be calculated as follows:
t = R(in Ω) * C(in Farads)
Try to use R1 = 1MΩ and C1 = 2.2µF, and with Ra and Rb set the level at ≈80% of Vs (supply) .. this should give you ≈1s delay ..

Regards,
IanP
 

op amp delay

Battery input voltage is 8.0v to 12v

i want Ra,Rb value

with regards [/img]
 

analog delay opamp

For Ra=10kΩ (100kΩ) and Rb=39kΩ(390kΩ) the 80% condidtion will be true for Vs=8V, but it won't be true for Vs=12V ..
If you would like to make this circuit independent of the Vs voltage, wire 1kΩ resistor in series between Vs and (Ra+Rb<->R1+C1), and an 8.2V zener diode in parallel with (Ra+Rb<->R1+C1) ..

Regards,
IanP
 

op amp time delay

madarchod lodo ghanta hila lo
behan ke lodo koi circuit nahi chal raha hai apni maa chuda lo
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top