Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

what kind of software support ATMEL's JTAGICE?

Status
Not open for further replies.
B

beo

Newbie level 2
Joined
Nov 15, 2005
Messages
2
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Activity points
1,303
I have been given a JTAGICE from a friend and need some tip about compilers that supports JTAGICE. I know AVR STUDIO from ATMEL supports it but is there others with a C-compiler and an easy interface?
 

Winavr is GCC port for Atmel AVR processors and it support debugging using JTAGICE but you still have to use AVR STUDIO for debugging code compiled with Winavr.
 

    B

    beo

    Points: 2
    Helpful Answer Positive Rating
WinAVR distribution contains also the avarice-gdb-insight toolchain...
 

    B

    beo

    Points: 2
    Helpful Answer Positive Rating
Thanks folks!

It seem to me i have a cheap choice and a expensive one. IAR is the expensive one. Winavr and avrstudio 4 is a little more complex but as cheep as it can be.

I have also found imagecraft V7 (https://www.imagecraft.com) may support jtagice with avrstudio, same as above. Codevision (https://www.hpinfotech.ro) also have some limited support if i understand it correct.

It seem to be more educationg anyhow to install Winavr. It may take a while to get continious developed tools to work but it may be worth it.

/BeO
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top