Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

shift register 74ls164

Status
Not open for further replies.
S

sush

Member level 4
Joined
Aug 24, 2005
Messages
78
Helped
3
Reputation
6
Reaction score
2
Trophy points
1,288
Activity points
1,946
datashift 74ls164

hi friends,

if i send some 8-bit serial data to shift register 74ls164 and stop, will the data be latched on output of this serial-to-parallel convertor 74ls164. if no, which ic or technique can i use to do the same.

thanks.
 

I think it is suitable to use 74LS595 it has latch.
 

You can use either 164 or 595 with the same effect .. 595 has additional latches and tri-state outputs ..
In both cases you need serial data and clock signal which has to synchronized with serial data ..
74164: when you clock data in and stop the clock signal data will stay in its parallel format ..
74LS595: the same as above but you need also to latch signal in output latches and activate outputs ..
Regards,
IanP
 

    S

    sush

    Points: 2
    Helpful Answer Positive Rating
Thanks a lot hassan1980 and especially IANP. 74ls164 worked out. I had not connected pin 9 (clear) of 74ls164 to postive. now after connecting it's working fine.

Anyway, Thanks once again.
 

sush said:
hi friends,
or technique can i use to do the same.

thanks.
Click to expand...

Simply, you can use D-FlipFlops in serial to complete your task! (But this is a bad way!:D)
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top