Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Help me choose between SMA and N connector

Status
Not open for further replies.
M

mudrik

Member level 3
Joined
Mar 5, 2005
Messages
56
Helped
10
Reputation
20
Reaction score
2
Trophy points
1,288
Activity points
1,835
Hi all,

I'am planning to build some RF modules, so I need informations about
connectors.
I must decide between N and/or SMA connectors.
My application should lie in region some GHz.
What types of connectors should I choose?

If I will buy the connectors in small quantities (10 to 20 pieces)
where can I get it in cheap prices ?

thanks and regards
 

Re: SMA and N Connector

SMA is much more mechanically convenient but has lower power rating compared to N. I assume you are operating under tens of Watts when I suggest SMA.

If you look at the minicircuits catalog, their N connector attenuators are rated to 6 GHz and the SMA ones are rated to 18 GHz.
 

Re: SMA and N Connector

how much power rating of your system, if the power is low, you can choose the SMA, if the power rating is high(>100W), then use the N connector, that is OK?
 

SMA and N Connector

N type is more rugger than SMA.
N is more "intuitive" if non-expert person should connect or disconnect.
Once connected to the opposite sex, N is splash proof, but remember that N and SMA are not rated as waterproof.
The cost and the rugger index depend on metal alloy. Stainless Steel is more expensive and more robust than Brass made connectors.
 
Hello,

We are specializse in manufactruer RF connector,maybe we can help you,welcome to visit our website:

**broken link removed**

B/R
Daisy

62_1337243387.jpg
67_1337243387.jpg
47_1337243387.jpg
15_1337243387.jpg


mudrik said:
Hi all,

I'am planning to build some RF modules, so I need informations about
connectors.
I must decide between N and/or SMA connectors.
My application should lie in region some GHz.
What types of connectors should I choose?

If I will buy the connectors in small quantities (10 to 20 pieces)
where can I get it in cheap prices ?

thanks and regards
Click to expand...
 

Besides,SMA has smaller size which is also in sonsideration.
 

All the above are good to consider. Also, N type connectors can be tightened by hand (finger tight), whereas SMA should be tightened with a torque wrench.
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top