Build-A-Burger
Full Member level 1
I had (2) t6963 LCD's, the one I think I hosed because I was converting the code from atmega328p to XMEGA128A4U and I had the chip enable inverted. I'm wondering if I just didn't wipe out the area of ram that holds the characters. Is there any software written (preferably in C) that I can use to check it or fix it? (I took some videos and put them on my YT channel. The first one is just random pixels, the second is supposed to be ascii characters - looks kinda blurry).
bad lcd:
https://youtu.be/Rh8jsOEa52s
good lcd:
https://youtu.be/Eu4Ulophw6A
bad lcd:
https://youtu.be/Rh8jsOEa52s
good lcd:
https://youtu.be/Eu4Ulophw6A