Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

How can I rename an entire Net with Proteus ISIS 7.1 ?

Status
Not open for further replies.

JagV12

Newbie level 3
Joined
Apr 21, 2018
Messages
3
Helped
0
Reputation
0
Reaction score
0
Trophy points
1
Activity points
23
Hi there,

Using Net names and Buses or Input/Output Terminals to hide wires on the schematics (Proteus ISIS 7.1) is very nice but what if I want to change the name of a Net from A0 to AD0 ?
The way I do it up to now is
1) Highlight Net on Schematic (single sheet so far)
2) Rename each individual Input, Output and Wire (in case of a Bus connection) with the PATool (shortcut "A", Net = AD0)
but there must be a better way, especially for multi-sheet designs...

Any suggestion ?

Next step : how to rename A0..A15 to AD0..AD15 (I doubt there is a "global" solution for this one)

Thanks
 

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top