Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Sign of S Parameters obtained by an FDTD code

Status
Not open for further replies.
P

peponas

Junior Member level 3
Joined
Nov 1, 2010
Messages
26
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Activity points
1,541
Hello,

I calculate S parameters using an FDTD code. I have monomode excitation and I calculate S-Parameters for more than 1 modes. I see that the |S11| below cutoff frequency of each mode is positive and very large. I know that this is due to the fact that each mode, below cutoff, is purely reactive. Are these results correct? How can I "correct" S11 in order to take negative |S11| below cutoff. Everything measured in dBs.

My technique is based on this https://ieeexplore.ieee.org/stamp/stamp.jsp?arnumber=1710860

Thank you in advance.
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top