skatefast08
Full Member level 3
I want to design a 2.4 GHz LNA prototype using 0402 components and FR4 board. Would you print out the schematic using OHP sheet and laser printer for the etching processes? What width size transmission line would you use? and the most important question, how would I solder the components on? would the etching and soldering process require any expensive equipment, where you would only find at a company or university (may I have to use a Mask SDE-3 or something)? would I be able to make this the same way as: https://www.instructables.com/id/DIY-PCB-Etching/, since my components are much smaller in size?
Thanks,
Thanks,