Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

How to remove effect of antenna from measurement result

Status
Not open for further replies.

amir_rch

Junior Member level 3
Joined
Dec 10, 2015
Messages
26
Helped
1
Reputation
2
Reaction score
1
Trophy points
3
Activity points
205
hello friends
can you tell me how to remove the antenna effect from measurment results?
i measured S21 with dipole antenna but this antenna have a little difference between simulation and measurment.
experimental setup for S21 measurment like this figure. Untitled.jpg
 

You might find the Wheeler Cap measurement technique useful. I suspect that you might be after an efficiency measurement or a method for separating directivity and gain.

Regards,

Azulykit
 
Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top