Ilya Rauschenbach
Newbie level 5
i have u-controller with two ethernets on the board (with mac and phy) and i want to assign address by a dhcp (or set its statically).
address was assigned succesful, udp server launched on every eth but only 1 eth works right.
my prog uses freertos and lwip. every eth separately works fine but not two at the same time.
how to resolve this problem?
:bang::bang::bang::bang:
address was assigned succesful, udp server launched on every eth but only 1 eth works right.
my prog uses freertos and lwip. every eth separately works fine but not two at the same time.
how to resolve this problem?
:bang::bang::bang::bang: