Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Eagle won't let me put vias down while routing a 4 layer board

Status
Not open for further replies.
T

treez

Guest
Eagle wont let me put vias down while routing 4 layer board

i have a 4 layer pcb that i am routing up.
It has layers (1*2)+(15*16).
When i route on the top and then select the bottom lyaer (16), it gives error "cant set via at -40,30 to layer 16".
It wont let me put vias down.
Do you know why?

- - - Updated - - -

i havent ever had this problem before.
I wonder if its because i am using a different pcb with different windows?

- - - Updated - - -

.................sorry .its ok now, my layer command was wrong
 

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top