Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

how to test a RF schottky diode with a multimeter

Status
Not open for further replies.
A

arezuabdi

Newbie level 1
Joined
Jun 24, 2017
Messages
1
Helped
0
Reputation
0
Reaction score
0
Trophy points
1
Activity points
11
Hello everyone :)
I was wondering if you answer the following question:
Could I test an RF schottky diode (as an example HSMS282x) with a multimeter like other typical diodes to make sure the diode does not burn and it is ok?
If no, could you please tell me how I do it?
thanks a million :)
 

Hi,

with a multimeter yo can´t measure HF features.
But you can test the DC specifications.

Like forward voltage drop:
Use a 10V supply (doesn´t need to be very exact).
Use an 1k resistor in series with the diode.
Measure the voltage across the diode.

It should be somewhere 300mV ... 500mV.
Loo low voltage or too high voltage shows a defective diode.

Klaus
 
  • Like
Reactions: arezuabdi

    V

    Points: 2
    Helpful Answer Positive Rating
    A

    arezuabdi

    Points: 2
    Helpful Answer Positive Rating
KlausST said:
Like forward voltage drop:
Use a 10V supply (doesn´t need to be very exact).
Use an 1k resistor in series with the diode.
Measure the voltage across the diode.
Click to expand...
Fortunately DMMs today have a diode test option so that you do not need to spend time for a simple diode test.
1.png
 
CataM said:
Fortunately DMMs today have a diode test option so that you do not need to spend time for a simple diode test.
Click to expand...
What characteristcs can you evaluate ?

Can you evaluate reverse voltage breakdown ?
Can you evaluate Idiode v.s. Vdiode with only DMM without DC signal source ?
 
pancho_hideboo said:
What characteristcs can you evaluate ?

Can you evaluate reverse voltage breakdown ?
Can you evaluate Idiode v.s. Vdiode with only DMM without DC signal source ?
Click to expand...
Only forward voltage drop.
 
Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top