Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

AC sim convergence issue

Status
Not open for further replies.
A

analog_chip

Full Member level 1
Joined
Oct 9, 2011
Messages
99
Helped
1
Reputation
2
Reaction score
1
Trophy points
1,288
Activity points
1,994
Hi, I am simulating a long chain of 40 delay cells. Each cell consists of one all pass delay cells and a buffer. There is a coupling cap between buffer and delay cell. Each unit cell has unity gain. After 30 stages the ac gain shows rough peaks showing convergence issue. I see a zig-zag curve instead of smooth one. How to fix this issue? Please help.
 

AC (small signal) analysis doesn't use iterative solver, don't see how convergence problems should be brought up. I rather guess it's a numerical resolution problem and too few frequency points. How much is the magnitude ripple? Can you show a plot?
 

What kind of simulator are you using? Cadence Spectre AC simulation can confuse when the ground of the input source is else then device model grounds.
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top