Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
"Ejector" is the suggested position of the vacuum nozzle in pick and place machine. If your PCB software has an dedicated pick-and-place center position, it could be used for it.
A pin 1 marking can be found somewhere in the "index area". Your package drawing should have a pin 1 marking.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
