Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

LTC3721 Push Pull Controller Adaption

Status
Not open for further replies.
A

artmaster547

Newbie level 4
Joined
Feb 20, 2018
Messages
6
Helped
0
Reputation
0
Reaction score
0
Trophy points
1
Activity points
54
Hi All
I would like to use the LTC3721 push pull controller from linear technologies to create the following converter:
Input of 12V output of +175V and another output of -175V, using a push pull configuration I think at the moment it is setup for 12V in and 5V if anyone could help me modify the model attached would really appreciate it.

Kind Regards

Art
 

that device is only 10Vin max - so make sure you have a reg to <10V on the Vcc pin - else bang

- - - Updated - - -

also logic level fets might need to be used that can handle 10V on the gate...
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top