Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Help me in ADS (Error Message during simulation)

Status
Not open for further replies.
noor84

noor84

Member level 5
Joined
Dec 27, 2017
Messages
90
Helped
0
Reputation
0
Reaction score
0
Trophy points
6
Activity points
688
Dear all,
I designing RF LNA and I want to simulate ,
but I have a problem as shown in attached file.
How can I know line4? where is line 4?
or any line that has the problem???
thanks in advance Untitled.jpg
 

Check the net-list that is found under the project directory.
I don't know the net-list but a current source and voltage source shoulnd't be connected as done.
Current source has to have a separate GND connection, voltage source has as well.Otherwise the simulator may create convergence errors.
 

Dear BigBoss ,
Many thanks for your reply,
about the design I take the cUntitled.pngircuit from PDF I attached the pic plz see it
 

noor84 said:
Please, how can I get line 9 or line 4 or ...
Click to expand...

:thinker:

When ADS opens the file in the text editor , start counting the lines.
In your PDF, there are extra line breaks for the long lines, so this can't be used.
 

It would be helpful if you learn to post readable images. I also notice that the posted netlist (besides line break problems) is for a different circuit, using different part designators than the schematics.
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top