Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Common Path Pessimism

Status
Not open for further replies.

vaibhavgahlot

Newbie level 3
Joined
Oct 7, 2017
Messages
3
Helped
0
Reputation
0
Reaction score
0
Trophy points
1
Activity points
19
What is common path pessimism removal (CPPR)? What are the various techniques of doing that?
 

Static timing analysis tools do setup and hold calculations based on 'early' and 'late' paths for clock and data.

For setup checks launch clock takes the 'late' path (max) and capture clock takes the 'early' path (min).
For hold checks launch clock is through the 'early' path and capture clock is the 'late' path.

For a synchronous design usually clocks for the launch and capture are coming from the same branch of a clock tree, so there's a common portion between these two paths which is originating from the same source.

So tools will calculate required and arrival times using late and early delays and finally adjust the delay calculation to cancel out the CPPR.

For setup checks :
Required time > Arrival time - CPPR

For hold checks :
Required time < Arrival time + CPPR

In both cases CPPR is going to reduce the pessimism in delay calculation.
 
The post above defines the problem pretty damn well. There are no alternative techniques to do CPPR as CPPR is a technique on its own. Just identify the gates shared by the launch & capture clock paths, reduce the 'spread' accordingly.
 

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top