Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
in atmega 8 could i use internal pull up resistor with push button and save the external resistor.? just make it pull up and connect the push button to ground
that´s how it is done many times.
But consider that it is relatively high impedance and thus prone to noise. --> no lengthy wiring, no noisy signal close to it.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
