Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Adding Dummies for folded cascod opamp output stage

Status
Not open for further replies.
MahmoudHassan

MahmoudHassan

Full Member level 6
Joined
Oct 4, 2010
Messages
349
Helped
44
Reputation
90
Reaction score
40
Trophy points
1,328
Activity points
3,913
Hi

I am attaching a photo for a folded cascod opamp for this circuit for example
For M9 and M10 I can add dummies connected to VDD all terminals, also for M3 and M4 but all terminals connected to ground
The problem is in M5 -M6 and also M7-M8 How can I add dummies to these transistors in interdigitated common centroid layout?

Capture.JPG

Best Regards,
Mahmoud
 

1) Dummies are dead simple when the outer (less
dummies) connection is the natural source supply.

2) Centroid layout is easier when every FET is made
up of 2*N segments, letting you configure placement
such that -every- FET sits on both sides of the
centerline. Like 5/1*2 rather than 10/1.

3) Whether fine-matching the PMOS stack may or may
not be worth the effort, depending on how much front
end gain there is.
 

I would do M7, M8, M9 and M10 as a group with dummies on the outside. Same for M3, M4, M5 M6.
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top