Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Using Qsys and Nios for sending serial data by Rs232

Status
Not open for further replies.

fatimamaz

Newbie level 5
Joined
Jan 29, 2018
Messages
10
Helped
0
Reputation
0
Reaction score
0
Trophy points
1
Activity points
68
By following the steps available in this website https://www.youtube.com/watch?v=nHFVwthr_Ew, it becomes easier to define the serial port. But what is the step after compiling to Nios? And is it necessary to open Nios whenever board programming is needed?
 
Last edited:

Hi,
But what is the step after compiling to Nios?
can you be more specific ? what you mean by compiling to nios?
And is it necessary to open Nios whenever board programming is needed?
did you mean eclipse ?

thanks
 

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top