Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Simulating Rectifier efficiency using ADS

Status
Not open for further replies.

Sherihan

Newbie level 1
Joined
Feb 21, 2018
Messages
1
Helped
0
Reputation
0
Reaction score
0
Trophy points
1
Activity points
10
Hello everyone,
i want to simulate a rectifier efficiency in ADS for different loads without taking the mismatch losses in consideration, so am i doing it right? (My simulation setup is attached here)

if i'm doing it right, why by changing the source impedance the values of max efficiency changes (as shown in the attached figures) although i'm not taking the mismatch losses in consideration?!
 

Attachments

  • ask0.PNG
    ask0.PNG
    65.1 KB · Views: 254
  • ask1.PNG
    ask1.PNG
    36.3 KB · Views: 221
  • ask2.PNG
    ask2.PNG
    64.6 KB · Views: 226
  • ask3.PNG
    ask3.PNG
    36.5 KB · Views: 207

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top