Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Opamp design in mentor graphics

Status
Not open for further replies.

gopalece

Newbie
Joined
Feb 23, 2018
Messages
5
Helped
0
Reputation
0
Reaction score
0
Trophy points
1
Activity points
57
I am designing opamp in mentor graphics.How can I get process parameters
vth, kn
 

What do you mean under "process parameters"?

Energy, doses, and angles of implants? Oxide thicknesses?

Or final doping profiles?

Or transistors' Vt values?

Or coefficients A determining device mismatch?

Your question is very vague...
 

How can I get Vth,Kn,mobility,oxide capacitance of mosfet in Mentor graphics
 

Design of opamp in mentor graphics

How can I know model of mosfet in mentor graphics(Technology 130nm).
 

Foundry PDK, which you would get from the foundry
you plan to fabricate at.

Or find one of the gpdk releases that match the node
if this is just a "paper exercise" that will never go to
fab.

"I want to build a house. What is lumber?"
 

Conceptually, this info is provided with PDK - which, physically, is a set of files stored on a disk somewhere - you need to ask people who installed the PDK, what is the path.
Some device parameters, measured characteristics, etc. may be found documents like Design Rule Manual.
 

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top