Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Metrix 440 Vibration Switch

Status
Not open for further replies.

Mohammad_Pirzadi

Advanced Member level 4
Joined
Nov 15, 2016
Messages
100
Helped
0
Reputation
0
Reaction score
0
Trophy points
16
Location
Khorramabad, Iran
Activity points
829
hi everyone
how can I jamp Metrix 440 Vibration Switch without tripping while the machine is working? i.e. how can I disconnect the vibration switch (for servicing) without shutdown the machine?
 

Attachments

  • Untitled.jpg
    Untitled.jpg
    388.7 KB · Views: 110

A simple (and possibly incorrect) suggestion is to connect a jumper across the two contacts which carry power, that is: (a) one going to the power supply, and (b) one going to the machine.
It could be the right suggestion only if your setup has the simplest possible electrical wiring. Or is your setup more complicated? Then you should post more photographs, and do not connect any jumpers until you get more expert advice.
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top