Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

How do you calculate s-params of a µ-wave amp with a component added to the common?

Status
Not open for further replies.
S

skatefast08

Full Member level 3
Joined
Jan 24, 2018
Messages
189
Helped
2
Reputation
4
Reaction score
2
Trophy points
18
Activity points
1,779
I am trying to figure out how to calculate the s-parameters of a common source/emitter amplifier with a component added between the source/emitter and ground; how would you express this as a 2 port network in a T-matrix (ABCD matrix)? would you have to do look at the high frequency signal analysis and then calculate h-parameters (or z-parameters), then convert to s-parameters? btw I do not have ADS software (free trials expired) and I am designing an LNA using MATLAB RF toolbox instead.
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top