Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

4-port s-parameter analysis in ADS

Status
Not open for further replies.
X

xzsawq21

Junior Member level 1
Joined
Jul 23, 2011
Messages
16
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Activity points
1,407
Hello
I have a differential filter that drawn as shown below in ADS schematic:
1.JPG2.JPG

first of all I need to check the reflection coefficient of this filter.
second I need to check the insertion loss of the filter.
I have placed 4 ports in the schematic. Do you see any problem in my schematic?
actually all four ports should be set on 50 Ohm and I don't know how I should set it.
in other Spice software I usually place a behavioral source to generate the output=out1-out2 but here I don't know what I should do...

Thanks
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top