watatayaya
Newbie level 3
Dear all,
I am currently working on 2 rectifier circuits. 1 of them is operating at 900MHz and 1800MHz, while the other is operating at 2100MHz and 2600MHz. I have simulate both circuits individually as well. The circuit designs are shown below.
As I would like to combine both the circuit outputs together, I have designed the following circuit as shown below.
With that, I am not quite sure whether the approach I had used to combine them is appropriate. In addition for the harmonic balance parameters, have I set it correctly for this configuration?
Thank you!
I am currently working on 2 rectifier circuits. 1 of them is operating at 900MHz and 1800MHz, while the other is operating at 2100MHz and 2600MHz. I have simulate both circuits individually as well. The circuit designs are shown below.
As I would like to combine both the circuit outputs together, I have designed the following circuit as shown below.
With that, I am not quite sure whether the approach I had used to combine them is appropriate. In addition for the harmonic balance parameters, have I set it correctly for this configuration?
Thank you!