Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Greber file generation in CST

Status
Not open for further replies.

nauma naseer

Junior Member level 3
Joined
Dec 22, 2008
Messages
26
Helped
1
Reputation
2
Reaction score
1
Trophy points
1,283
Activity points
1,477
Dear all
I had design a co-planer SRR array in CST, I am facing some problem while generating greber file.
I generated greber file by following method:
Import/export-----> 2D files ------->Greber(Single layer)
after that cst mark the boundary of substrate and upon clicking ok cst generate greber file which just have a rectangular substrate layer and did not show conducting layer (Split rings )
How can İ generate greber file which should contain contacting layer. Design is attached.
Regards
Noaman
 

Attachments

  • Untitled.png
    Untitled.png
    480.3 KB · Views: 118

Hi,

I think that in CST, you are generating Gerber data from the motive laying in xy plane (z=0). You can alternatively use a local coordinate system and align the uv plane, so that it "cuts" your motive parallel to the xy plane.
 

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top