Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Convert 0 to 10 volts into from 5 to 0 volts

Status
Not open for further replies.
Medtronic

Medtronic

Full Member level 5
Joined
May 19, 2005
Messages
246
Helped
29
Reputation
58
Reaction score
16
Trophy points
1,318
Location
Egypt
Activity points
2,694
Convert 0 to 10 volt into from 5 to 0 volt

Dear all my friends
i have an input volt from 0 to 10 volt ... i need to change it to 0 to 5 V with reverse action ... means i need when input is 10 the out is 0 and when input is 0 the out is 5 v

how can i get this

Thanks in advance

MedTronic
 

Re: Convert 0 to 10 volt into from 5 to 0 volt

your requirement does not specify whether you want linear response (i/p 0 to 10v and o/p 5 to 0v with inbetween ranges)
or for only extremes.( with 10v i/p 0v o/p and 0v i/p 5v o/p.)
 

Re: Convert 0 to 10 volt into from 5 to 0 volt

I read it as inverting amplifier specification, G = -0.5, +10V output offset.

Simple inverting OP circuit, R1 = 2*R2, n.i. input biased with 3.3V reference voltage.
 

Re: Convert 0 to 10 volt into from 5 to 0 volt

I need a linear response ... for Fvm please give schematic ... thanks very much
 

Re: Convert 0 to 10 volt into from 5 to 0 volt

Hi,

for Fvm please give schematic
Click to expand...
Is it asking too much to google for "inverting amplifier circuit" on your own?

You will find many thousands of hits. Almost all describe the same.
Many of them have detailed description about operation and part value calculation.

Klaus
 

Re: Convert 0 to 10 volt into from 5 to 0 volt

Here you have it with the explanation: https://payhip.com/b/5Srt

opamp inverting.png
 

Re: Convert 0 to 10 volt into from 5 to 0 volt

Below is the LTspice simulation of the inverter circuit with the required offset to give 5V to 0V from a 0V to 10V input with a single 5V supply voltage.
For other supply voltages, the ratio of R2 and R4 will need to be changed.
If high accuracy is needed then the voltage to R2 should be from a voltage reference.

Capture.PNG
 

Re: Convert 0 to 10 volt into from 5 to 0 volt

I apologize for my post above. I forgot to check the preview of the e-book. The inverting configuration is not in the preview, but in the paid version. Here you have free materials about the inverting configuration that should help you to understand this configuration:

- https://www.youtube.com/watch?v=U1KbM4ffiLg
- https://slideplayer.com/slide/3331407/ s.20
- https://slideplayer.com/slide/6231746/ s.28-29
- https://slideplayer.com/slide/3187860/ start at 1:40

Hope that will help.
 
Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top