Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

XILINX VIVADO:Two Simplex Aurora Loopback connection_Test result Fail

Status
Not open for further replies.

AbinayaSivam

Member level 1
Joined
Jul 27, 2017
Messages
38
Helped
0
Reputation
0
Reaction score
0
Trophy points
6
Activity points
345
Hello,
I have generated two simplex aurora cores one as TX and the other with direction RX (as shown in block diagram). I have loopback the TX output to the RX inputs and verified this loopback.

Two simplex Aurora was working in Single DAQ Board through Loopback connection, whereas two simplex Aurora was not working from one DAQ Board (TX) to other DAQ Board (RX) through Loopback connection.

In TX, I am getting 4 as TX length and counter values as TX data but I am getting 0 as RX length and 0 Values as RX data.

I do have deadline to complete my task so even i have posted my issues in XILINX FORUM. Suggest me what is wrong in my design. Please anyone help me.

The XILINX FORUM link as follows **broken link removed**

Block Design as shown below
Aurora_Int.PNG
 

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top