AbinayaSivam
Member level 1
Hello,
I have generated two simplex aurora cores one as TX and the other with direction RX (as shown in block diagram). I have loopback the TX output to the RX inputs and verified this loopback.
Two simplex Aurora was working in Single DAQ Board through Loopback connection, whereas two simplex Aurora was not working from one DAQ Board (TX) to other DAQ Board (RX) through Loopback connection.
In TX, I am getting 4 as TX length and counter values as TX data but I am getting 0 as RX length and 0 Values as RX data.
I do have deadline to complete my task so even i have posted my issues in XILINX FORUM. Suggest me what is wrong in my design. Please anyone help me.
The XILINX FORUM link as follows **broken link removed**
Block Design as shown below
I have generated two simplex aurora cores one as TX and the other with direction RX (as shown in block diagram). I have loopback the TX output to the RX inputs and verified this loopback.
Two simplex Aurora was working in Single DAQ Board through Loopback connection, whereas two simplex Aurora was not working from one DAQ Board (TX) to other DAQ Board (RX) through Loopback connection.
In TX, I am getting 4 as TX length and counter values as TX data but I am getting 0 as RX length and 0 Values as RX data.
I do have deadline to complete my task so even i have posted my issues in XILINX FORUM. Suggest me what is wrong in my design. Please anyone help me.
The XILINX FORUM link as follows **broken link removed**
Block Design as shown below