Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Systevue atennuator power level problem

Status
Not open for further replies.

antenna_beginner

Member level 2
Joined
Feb 11, 2017
Messages
47
Helped
0
Reputation
0
Reaction score
0
Trophy points
6
Activity points
363
Hello ,in the attenuator i have defined the insertion loss of 0.4dBm , however in the plot i can see a reduction of 6dBm
as you can see in the attached plot and settings of attenuator.where did i go wrong?

Thanks
plot.JPG
schematics_settings.JPG
 

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top