Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
This is my external EEPROM circuit.Some times while reading the data the values are changed from written value.
How to solve this solve this..Is the pull resistor value is correct or have to change the value..?
it looks like an EAGLE schematic.
u
Usually EAGLE automatically places junction dots to show which signal crossings are connected.
I wonder how you made the schematic without the junctions.
Please add the junctions so we can better verify your schematic.
***
Show your software.
Show the expected and the wrongly read values.
Show a scope picture with SCL and SDA of a write cycle. And the same for a read cycle.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.