Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

About quantifying Eye Diagram

Status
Not open for further replies.

aguntukbd

Newbie level 6
Joined
Jun 30, 2017
Messages
14
Helped
0
Reputation
0
Reaction score
0
Trophy points
1
Activity points
255
Hello,
I need help quantifying Eye Diagram. I have to quantify Eye Diagram at the end of my Thesis for my Serial Link channel. Viewing an Eye Diagram, I can say probably whether it is bad or good. But for the hypothesis or any conclusion qualitative analysis is not enough. I need to have quantitative analysis. I know what parameters are there like jitter, eye width, height, crossing level etc. etc. But how to say up to which value of parameters the eye diagram is good. like how can I decide that like 35% BER or x ps jitter is tolerable for the serial link (Though it depends on circuit & signaling techniques etc...)? Simply to ask what separates a good ee diagram from a bad one?

I am sorry to bother you again. If you have any note or suggestion or anything regarding my specific question will be appreciated.
 

One way is to use an eye pattern template. This page might help you get started.
 

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top