okalman
Newbie level 3
Hi!
I've made a pickit2 clone. The schematic is the same as in the documentation.
The problem is that software cant recognize the programmer. In device manager I can see "unknown usb device". When I plug in the programmer the red led starts to blink. If I press programmer button stops blinking, but the "unknown usb device" disappears in device manager.
I've programmed the 18F2550 mcu with art2003 schematic in low voltage mode. I was not able to change lvp config bit. Could it cause the problem?
Thanks for reply.
I've made a pickit2 clone. The schematic is the same as in the documentation.
The problem is that software cant recognize the programmer. In device manager I can see "unknown usb device". When I plug in the programmer the red led starts to blink. If I press programmer button stops blinking, but the "unknown usb device" disappears in device manager.
I've programmed the 18F2550 mcu with art2003 schematic in low voltage mode. I was not able to change lvp config bit. Could it cause the problem?
Thanks for reply.