Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

When creating a circuit inside Proteus, how do I configure fuse bits?

Status
Not open for further replies.
J

jfminformatica

Junior Member level 3
Joined
Dec 27, 2017
Messages
26
Helped
0
Reputation
0
Reaction score
0
Trophy points
1
Activity points
236
I'm working with Proteus 8 and sometimes I get a circuit already created on the internet that uses PIC, it's necessary to configure the fusebits to work perfectly. How do I do ?
 

Double click the microcontroller in the sheet, and you'll se some fuse options.
 

To perform the simulation, you need the .hex or .asm file for the specific PIC. You can configure the path under the part setup.
 

Attachments

  • PIC_hex.png
    PIC_hex.png
    35.9 KB · Views: 205

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top