Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Fast Ethernet RJ45 on gigabit transceiver

Status
Not open for further replies.

JoseL

Newbie level 5
Joined
Apr 19, 2014
Messages
10
Helped
0
Reputation
0
Reaction score
0
Trophy points
1
Activity points
80
Hello,

I'm currently designing a PCB which will be connected to another board which contains a gigabit Ethernet transceiver (Marvell Alaska 88E1512). The thing is that I don't need gigabit with 100/100 Ethernet would be more than enough, so in my board I want to route the signals to this RJ45 fast Ethernet jack: https://www.sparkfun.com/datasheets/Prototyping/MagJack.pdf.

From the gigabit transceiver I've got 4 pairs: MDI0_P & MDI0_N / MDI1_P & MDI1_N / MDI2_P & MDI2_N / MDI3_P & MDI3_N. (no sure which ones would be Tx or Rx)

So I'm thinking to do the connections like this:

MDI0_P & MDI0_N -> P1 and P2

MDI1_P & MDI1_N -> P7 and P8

P4 & P5 -> NC

P6 & P3 -> Vcc

would it work this setup?

Thanks.
 

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top