Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Help with using FilterPro

Status
Not open for further replies.
A

Aladin_Rj

Newbie level 1
Joined
Dec 29, 2017
Messages
1
Helped
0
Reputation
0
Reaction score
0
Trophy points
1
Activity points
7
I am trying to make an active bandpass filter with the frequencies of 300Hz and 12000Hz, however I can not configure the filterpro, I am from Brazil and I can not understand the video of ti that is in English. Could anyone tell me how to configure these frequencies in FilterPro?
 

A bandpass with 300 Hz and 12 kHz cut-off frequencies should be designed as combination of separate high- and low-pass filters. Define the required filter steepness, select a suitable filter characteristic, in case of doubt Butterworth and you are done.
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top