Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

mesh problems in CST

Status
Not open for further replies.

Ahmedtechno

Newbie level 2
Joined
Dec 28, 2017
Messages
2
Helped
0
Reputation
0
Reaction score
0
Trophy points
1
Activity points
13
Dear readers ...
I am MTech student i am working on displacement sensor using microstriop antenna and SRR technique.
when I moving the SRR above the feed line from 0.1 to 0.4 mm the program sends an error massage, it says that : ( port 2 is inhomogeneously filled with first 3 mesh cells . cannot start solver ).
what did that mean and how can i solve this problem ?
my best wishes.. error.PNG
 

You should set the boundary conditions to open(add space).
 

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top