Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Altium: 3d budy Snap point

Status
Not open for further replies.
B

baby_2

Advanced Member level 4
Joined
Jul 20, 2016
Messages
105
Helped
2
Reputation
4
Reaction score
1
Trophy points
18
Activity points
873
Hi,
I want to select snap point to the center of my 3d shape.As you can see I change the reference point to the middle of my PCB foot print and I measure the length and width of my 3d-shape.
1.JPG
However by dividing the length and width by 2 I wasn't able to select the middle point of 3d-shape, what is my mistake?
2.JPG
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top