Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Why legs of dip switch are bended?

Status
Not open for further replies.

Vraj

Advanced Member level 4
Joined
Jul 15, 2016
Messages
119
Helped
2
Reputation
4
Reaction score
2
Trophy points
18
Activity points
1,038
Hi,

question2.png

Why legs of Dip switch are bended?

For hanging on position while soldering?


Thanks
 

Yes, it's a kind of snap-in feature for stable placement during solder. Observe the drill dimensions given in the datasheet.
 
  • Like
Reactions: Vraj

    V

    Points: 2
    Helpful Answer Positive Rating

    Vraj

    Points: 2
    Helpful Answer Positive Rating
Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top